Drillco 5000A Series High-Speed Steel Regular Length Finishing Center Cutting End Mill, Uncoated (Bright) Finish, 2 Flute, 30 Degrees Helix, Square Nose End, 13/16" Cutting Length, 13/32" Cutting Diameter, 2-1/2" Length, 3/8" Shank Diameter

Drillco two-flute end mill is a hard working center cutting tool and can be used for multiple operations, plunge cutting and slotting, drilling and profiling, which can minimize the number of tools required to complete a given job. Since this end mill have only two cutting edges, the flute is deeper and longer than end mill with more cutting edges, providing more chip carrying capacity. The two-flute end mill is an ideal tool for milling operations that begin with a plunge cut and, in general, heavy cuts where the tool is "buried" in the work and chip removal is a problem. High-speed steel tool is good for most general purpose application, offering a combination of hardness and toughness for wear resistance. Uncoated tool feature just the base substrate without any additional treatment or coatings and is suitable for a wide range of applications. Weldon shank feature a round shank with one of more flats machined into the side for easy indexing and alignment. When run in a counterclockwise direction (right-hand cut) spiral fluted tool evacuate chips up and out of the cut to reduce clogging.

• High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance
• Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications
• Weldon shanks feature a round shank with one of more flats machined into the side for easy indexing and alignment
• When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging
• Used for multiple operations, plunge cutting and slotting, drilling and profiling, which can minimize the number of tools required to complete a given job